WIFI VIDEO DOOR PHONE V-102207
WiFi Touch Screen Picture Capture Video Recording Video Doorphone Work with Tuya
1) Monitor from your smart phone
2) Answer the call from outdoor unit& your smart phone
3) Unlock the electric lock and gate opener by outdoor unit& your smart phone
4) Picture Capture& Video recording by your smart phone
|Input Power Supply||AC 100V-240V / 50-60Hz|
|Output Power Supply||15 V DC 0.8A|
|Screen||7 inch TFT LCD touch screen|
|LCD resolution||800(RGB) x 480|
|Number of connecting cables||2 wire|
|Cable requirement||0~50m: 0.75mm2 ; 0~100m: 1mm2|
|Power consumption||≤2.7W (when standby); ≤9W (when working)|
|Memory capacity (photos)||Build-in memory (14MB) when full the newest photo will automatically overwrite the oldest one|
|Working temperature range||0°C ~ +50°C|
|Dimensions (H x W x D)||218 x 112 x 25 mm|
- To ensure the WIFI indoor unit better received the signal, there are three recommendations.
1)The WIFI indoor unit and the WIFI routers should be in the same room or space and as close as possible.
2)Do not install the WIFI indoor unit in a room with a shielded metal layer.
3)It is not recommended to install the WIFI indoor unit and wifi router on a partition wall.
2. The following reasons may cause the network fail.
1)Your WiFi router uses a 5G WIFI network. (The WIFI indoor unit only support the 2.4G WIFI network recently.)
2)Incorrect wifi password.
3)The network is unstable.
4)The WIFI indoor unit and the smartphone are not in the same network segment.
Connect the WIFI indoor unit with smartphone through TuyaSmart app.
- Download and install the Tuya App.
- Connect the smartphone to the WIFI router.
- Connect the WIFI video doorphone to the network.
1)Open the”TuyaSmart” app
2)In the first page, add the device.
Click”+”in the upper right corner of the page or click the “Add Device”place.
3)In the second page, choose the range.
It belongs to”Video Surveillance”range ==> “Smart Doorbell”.
4)In the third page, you will hear the tone ” Please scan the wifi QR code” . Then click “next”.
5)In the fourth page, enter the account and password of the wifi router. Then click “next”.
6)In the fifth page, pairing the QR code
Place the phone at the camera of the outdoor unit until you hear the prompt “QR code scanning succeed”. Then click “next”.
7)In the sixth page, the device is connecting.
You will hear two tones”WIFI connection succeed.” and”The device can start to be used.”
8)In the seventh page, modify device name and the location.
9)Click “Done” in the upper right corner of the page after modify the device name and location, the smartphone interface will be shown as below.